Equalizer Systems Auto-Level Troubleshooting & Warranty Manual

Leveling system for rv factory
Hide thumbs Also See for Auto-Level:

Advertisement

Auto-Level -Troubleshooting & Warranty Guide
Contents
Setting the Null.................................................................Page 2
Helpful Hints ....................................................................Page 2
Panel Indicators ................................................................Page 3
Manual Override...............................................................Page 4
Troubleshooting................................................................Page
5
Warranty ...........................................................................Page 7

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Auto-Level and is the answer not in the manual?

Questions and answers

Richard C Wiechman
May 1, 2025

all lights are on and unit will not power down

Summary of Contents for Equalizer Systems Auto-Level

  • Page 1: Table Of Contents

    Auto-Level -Troubleshooting & Warranty Guide Contents Operation / Manual & Auto-Level ........Page 1 Setting the Null..............Page 2 Helpful Hints ..............Page 2 Panel Indicators ..............Page 3 Manual Override...............Page 4 Troubleshooting..............Page Warranty ................Page 7...
  • Page 2: Operation / Manual & Auto-Level

    The LED light next to the Power button should be lit RED when power is on. If you attempt to extend jacks by pressing the Down keypad buttons or all the jacks with the Auto-Level button, you will hear a “deny”...
  • Page 3: Setting The Null

    Setting the Null: Null is the term used to indicate the levelness of the coach If the coach is not level following an attempt to Auto-Level, you will need to level the coach and reset the null. To set the null, push and release the Power button on the Keypad to engage power. The LED light next to the Power button should be lit RED when the power is on.
  • Page 4: Panel Indicators

    'IGNITION ON' OFF when ignition is off May not be present on newer trailer version units- See Step 8 (installation) LED .........ON Red following an Auto-Level attempt if 'EXCESS SLOPE' system cannot overcome slope OFF when slope is not excessive ...
  • Page 5: Manual Override

    Manual Override Procedure  Your hydraulic motor is equipped with a manual override output shaft. You must use a drill with a 7/16" socket driver.  The drill must be capable of producing a minimum of 2000 r.p.m. for the pump to develop appropriate pressure output.
  • Page 6: Troubleshooting

    Controller installed improperly or has Check controller orientation moved Ignition switch in wrong position Check and change as needed Auto-Level will not level Damaged or defective Keypad or Call Equalizer Systems Controller harness Defective Keypad or Controller Call Equalizer Systems...
  • Page 7 Proper and adequate grounding of the pump is essential 80% of the calls we receive are found to be a discharged battery or poor ground If your problem is not listed, call Equalizer Systems at (800) 846-9659 Prior Authorization for warranty is required...
  • Page 8: Warranty

    1. Only warranty claims with prior written or verbal authorization from Equalizer Systems will be recognized, all other claims will be denied. 2. Equalizer Systems warrants slide out and leveling system components for a period of one year from the date of original sale of the vehicle. This warranty covers defects in material and workmanship only.

Table of Contents