Table of Contents
Advertisement
The display will show the name of the current file in the upper left-hand corner of the screen and the
sequence number of the measurement in the upper right-hand corner. Below these the parameter
names appear on the left and parameter values on the right of the screen.
Figure 3. CI-203 display read out and key pad
To bring an image into view, press the RIGHT arrow key. Pressing the RIGHT arrow key again will
display the barcode data. Pressing the LEFT arrow key from any screen will return the instrument to
the ready to measure mode. To discard the last measurement, press the STOP button. Now another
measurement may be taken, if required. Depending on the setup of the automatic save function of the
instrument, the measurement will or will not be saved.
Figure 4. Image of measured leaf on CI-203 display screen
To save the measurement, press the SAVE button; the word "saved" will be shown near the top line of
the display to confirm that the data is saved. Make sure the SDcard is present when saving data to a
file. The user may verify and transfer files by connecting the instrument to a computer using the USB
port on the CI-203, or by mounting the SDcard into the SD slot on the computer and using it as a local
drive; then open the file explorer to view the files. Files should be copied from the SDcard and saved
to the hard drive before proceeding with any calculations or data manipulation.
1554 NE 3
Ave, Camas, WA 98607, USA
rd
Phone (360) 833-8835 Fax (360) 833-1914
sales@cid-inc.com http://www.cid-inc.com
CI-203 Instruction Manual rev. 8/9/2016
6
Advertisement
Table of Contents
