Table of Contents
Advertisement
2. Connect a suitable 9V DC power source, such as the AC adapter supplied by CID Bio-Science,
Inc., to the power input socket on the back of the CI-203CA.
Figure 10. The RS232 port and the Power Jack of the CI-203CA.
3. Press the power switch on the CI-203CA (see Figure 10) to the ON position.
Note: The CI-203/CI-203CA combination must be turned on with the switch for the CI-203CA in order
to take measurements!
Anytime a CI-203 is reinserted into the conveyor, or if any problems are encountered, press the right
and left buttons simultaneously. This will match the conveyor to the CI-203. It will run for a few
seconds, then turn off. Repeat this twice.
1554 NE 3
Ave, Camas, WA 98607, USA
rd
Phone (360) 833-8835 Fax (360) 833-1914
sales@cid-inc.com http://www.cid-inc.com
CI-203 Instruction Manual rev. 8/9/2016
30
Advertisement
Table of Contents
