Advertisement
(3) CLIENT (CL) MODE SETUP
When configured in Client mode, the UBH1706 can enable
wireless capability for a networking device. It essentially acts as a
wireless network card when connected to a computer, DVD player,
Internet TV, or game console via an Ethernet cable.
Client Mode
Ubee
UBH1706
Enable Wireless
Capability
For initial setup, the UBH1706 should be installed in close
proximity (in the same room) to the access point (wireless router
or gateway). After installation the device can be moved to achieve
maximum signal strength.
To enable wireless capability for your networking device, use
either of the following methods:
•
WPS (Wi-Fi Protected Setup)
•
Web User Interface (UI)
Game Console
or
Smart TV
or
DVD/Blu-Ray Player
www.ubeeinteractive.com
UBH1706-AA00 Quick Installation Guide
Using the WPS (Wi-Fi Protected Setup) Button
When both devices are WPS capable, you can join a secure WiFi
network without entering the network name and password.
1.
Switch the UBH1706 to Client (CL)
mode.
Plug the UBH1706 into a power outlet.
2.
Within a few minutes, you should see
the Power LED light up. If the power
LED does not light up, check that the
power outlet is working properly.
Connect one end of an Ethernet cable to
3.
your computer's Ethernet port and the
other end to the Ethernet port on the
UBH1706.
Press the WPS button on the UBH1706
4.
and hold for 2 seconds. The WPS LED
will start flashing.
Within 2 minutes of pressing the
5.
UBH1706 WPS button, press the WPS
button on the access point with which
you are connecting.
Access Point
WPS Button
AP
RP
CL
Power
LED
WPS
LED
WPS
Button
5
Advertisement
