Appendix; Resetting Your Zūmo - Garmin zumo 500 Owner's Manual

A
PPENDIX
A
PPENDIX
Installing the zūmo in
your automobile
Your zūmo 550 includes an additional
cradle mount for your automobile so
you can easily transfer the unit. Select a
suitable location in your vehicle for safe
power cord routing and safe operation.
To install the zūmo into the auto
mount:
1. Place the suction cup on the
windshield. Flip the lever back,
toward the windshield.
2. Place zūmo into the cradle mount
3. Plug the power cable into the side of
the zūmo cradle mount.
➊
36
4. Snap the socket on the back of the
zūmo onto the ball on the end of the
suction cup arm.
5. Plug the power cable into a power
receptacle in your vehicle. Your
unit should turn on automatically if
it is plugged in and your vehicle is
running.
To remove the zūmo from the mount,
turn the zūmo as far as you can to the
right or left. Apply pressure in that
direction until the zūmo snaps off the
mount.
To remove the suction cup from the
windshield, flip the lever toward you.
Pull the tab on the suction cup toward
you.
➋
➌
Windshield
zūmo 500/550 Owner's Manual
Mounting on Your Dashboard
Use the enclosed mounting disk to
mount your unit to the dashboard and to
comply with certain state regulations.
Important: The permanent mounting
adhesive is extremely difficult to remove
after it is installed.
To install the mounting disk:
1. Clean and dry the dashboard where
you are placing the disk.
2. Remove the backing from the
permanent mounting adhesive on the
bottom of the disk.
3. Place the disk on the dashboard.
4. Place the suction cup mount on top of
the disk. Flip the lever down (toward
the disk).
Suction
cup
Lever
Disk
zūmo 500/550 Owner's Manual
A
PPENDIX
Resetting Your zūmo
If your unit locks up (freezes up), press
and hold the Power button and tap
the Page key.
NOTE: If you need to reset your unit
often, update the system software.
See page 33 for information about
updating the software.
37