Recording Your Performance (Phrase Recording) - Yamaha PSR-E263 Owner's Manual

Recording Your Performance (Phrase Recording)

You can record your performance as a User Song (Song number 113), which can then be
played back on the instrument. The recorded User Song can be played back in the same
way as the preset Songs.
NOTE
• A total of approximately 300 notes can be recorded to the User Song.
1
Select the desired Voice.
2
Press the [PHRASE REC] button to
enable the Record mode.
001
To exit from the Record mode, press the
[PHRASE REC] button again. (The display stops
flashing.)
NOTICE
• If the User Song is recorded, the data will be recorded
over and erased (you will record over and erase previ-
ous data in "User Song").
3
Play the keyboard to start recording.
NOTICE
• Never attempt to turn the power off or connect or dis-
connect the AC adaptor. Doing so can result in a loss
of data.
NOTE
• When recording capacity becomes full during recording,
a "Mem Full" message appears on the display, recording
is stopped, and the Song select display is shown.
• If you press the [START/STOP] button, even if you don't
play the keyboard, recording starts.
Limitations while recording:
• The following settings/operations cannot be
recorded: Reverb Level, Style, metronome click,
Transpose, Tuning.
• The following settings and buttons are not avail-
able, or if operated, the new settings cannot be
recorded:
Split Point, Reverb Type, Chorus Type, [FUNC-
TION] button, [PORTABLE GRAND] button.
UserSong
Flashes
4
Press the [START/STOP] button to stop
recording.
5
To play back the recorded Song, press
the [START/STOP] button.
NOTE
• If you make a mistake or want to erase an existing Song,
you can delete the User Song. To do this, enable the
Record mode in step 2, and then press the [START/
STOP] button twice in succession (without playing the
keyboard).
PSR-E263 YPT-260 Owner's Manual
29