Setup Location Requirements; Installation Of The Appliance - Caso C1000M Operating Manual

15.5 Setup location requirements:

In order to ensure the safe and trouble-free operation of the device, the setup location
must fulfil the following prerequisites:
 The device must be set up on a firm, flat, horizontal and heat-resistant surface with
sufficient load-bearing capacity for the oven and the maximum weight of the expected
food that is to be prepared in the oven.
 Choose the setup location in such a way that children cannot reach any hot surfaces on
the device.
 The device is not intended to be installed in a wall or a built-in cupboard.
 Do not set up the device in a hot, wet or extremely damp environment or near
flammable material.
 Ensure that the power cable does not hang down over a table or counter edge.
 The electrical socket must be easily accessible so that the power lead can be
disconnected easily, in the case of an emergency.
 The installation and assembly of this device in non-stationary setup locations (e.g. on
ships) must be carried out by specialist companies / electricians, provided they
guarantee the prerequisites for the safe use of this device.

15.5.1 Installation of the appliance

c) The left side of the device must be open.
d) Do not remove the feet from the bottom of the appliance.
e) Do not cover or obstruct any openings in the appliance.
f) Covering the ventilation slots may cause damage to the appliance.
g) Place the microwave appliance as far away from radios of TVs to minimize any
interference to radio and TV reception.
2) Insert the power plug into a normal household outlet; check that voltage and
frequency of the appliance (see appliance rating label) matches that of the
household electrical supply.
caso C1000M
1) Select a level surface
providing enough distance
between the ventilation slots
and walls or other units.
a) The surface for placing the
appliance must be at least 85
cm above the floor.
b) The rear of the appliance must
be facing a wall (10 cm
distance). Above the
appliance a clearance of 30
cm is needed, and on the
sides at least 20 cm distance
to other walls or units are
needed.
44