Tuning To Preset Radio Stations; Erasing A Preset Radio Station; Changing Tuning Grid - Philips FWV595 User Manual

Radio Reception
Notes:
– If you attempt to store more than 40 preset
radio stations, "PROGRAM FULL" will be
displayed.
– During programming, if no button is pressed
within 20 seconds, the system will exit the
Programme mode automatically.

Tuning to Preset Radio Stations

Once you've preset the radio stations, press í
or ë to select the desired preset number.
The preset number, radio frequency, and
waveband will appear on the display.

Erasing a Preset Radio Station

1 Press í or ë to select the preset radio station
to be erased.
2
Press and hold Çon the system until "PRESET
DELETED" appears on the display.
The radio frequency remain on the display.
The preset numbers of all other preset radio
stations in the band with higher numbers are also
decreased by one.
Repeat steps 1–2 to erase other preset radio
stations.
For Recording, please refer to "Tape
Operation/Recording".
24

Changing Tuning Grid

In some countries, the frequency step between
adjacent channels in the MW band is 10 kHz (9
kHz in some areas). The preset frequency step
in the factory is 9 kHz.
Changing the tuning grid will erase all
previously stored preset radio stations.
1
Disconnect the system from the AC power
supply (pull out the AC power cord).
2
While holding down TUNER and á on the
system, reconnect the system to the AC power
supply.
The display will show "GRID 9" or "GRID
10".
Notes:
– GRID 9 and GRID 10 indicate that the tuning
grid is in step of 9 kHz and 10 kHz respectively.
– The FM tuning grid also will be changed from
50 kHz to 100 kHz or vice versa.