Get Started; Set Time And Date - La Crosse Technology 616-146v2 Quick Setup Manual

Step 1:Insert the included 5-volt AC power adapter into projection
Alarm and then into wall outlet.
Step 2:Insert 2new"AAA" batteries (not included) into the projection
alarm. Observe the correct polarity.
Step 3:Insert 2 new "AA" batteries (not included) into the TX141v2
sensor. Observe the correct polarity. The red LED will flash
when transmitting.
Step 4: After 5 minutes place the sensor outside in a shaded location.
Note: If the outdoor temperature is not displayed after 3 minutes, hold
the +/TEMP button to search for outdoor sensor. Then, press the
TX button on the sensor to send signal.
1. Hold the SET/°F/°C button to enter time set mode.
2. Use the +/TEMP or -/TIME buttons to adjust values.
Press and hold for fast adjustment.
3. Press the SET/°F/°C button to confirm adjustments and move to
the next item.
Time and Date setting order:
1. WWVB(ON/OFF)
2. Time Zone
3. DST Daylight Saving Time (ON/OFF)
4. 12/24 Hour Time Format
5. Hour
6. Minutes
7. Year
8. Month
9. Date
Note: Day of the week sets automatically.
Press the SET/°F/°C button to exit, or wait 20 seconds without
pressing buttons to return to the normal time display.
Press the SET/°F/°C button to select Fahrenheit or Celsius
temperature display.
Model: 616-146v2

GET STARTED

SET TIME AND DATE

FAHRENHEIT/CELSIUS
www.lacrossetechnology.com/support Page | 2