W2 Installation - Barnett Engineering ProTalk LINK Operating Manual

W2 INSTALLATION

10. W2 INSTALLATION
STATUS
1
INPUT
1 2 3 4 5 6
The W2 module provides wireless callout capability through an embedded
CDMA cell phone. In addition to communications functions, this module
also has 8 digital inputs that can be independently programmed to operate
as one of five different types:
 Standard digital
 Watchdog timer
 Interval timer
 Totalizer
 Accumulator
There are also 4 relay outputs that can be used for remote control; these
relays are controlled by incoming DTMF codes.
A limited amount of programming can also be done using a safety
approved Touch-Tone telephone locally or by calling into the module.
This module can be used to transfer a database to the ProTalk Link if the
internal cell phone is registered with a data plan through the wireless
carrier. It can also transfer data between the external DB9 connector and
the cell phone's modem. See the LINK.EXE PC application's Help
section for details on using these features.
Connectors
Refer to Figure 29 below for details of the connector pin outs.
ALARM OUTPUT
2 3 4 5 6 7 8 1 2 3 4
OUTPUT 1 OUTPUT 2
7 8
Figure 28 W2 Module Front Panel
Figure 29 W2 Module Connections
OUTPUT 3 OUTPUT 4
PAGE 33
DATA
B1285-W2