W1 Installation - Barnett Engineering ProTalk LINK Operating Manual

PAGE 28

9. W1 INSTALLATION

STATUS
1
INPUT
1 2 3 4 5 6
The W1 module provides wireless callout capability through an embedded
GSM cell phone. In addition to communications functions, this module
also has 8 digital inputs that can be independently programmed to operate
as one of five different types:
 Standard digital
 Watchdog timer
 Interval timer
 Totalizer
 Accumulator
There are also 4 relay outputs that can be used for remote control; these
relays are controlled by incoming DTMF codes.
For more advanced callout requirements, the module can be configured to
send email messages containing the alarm information. A limited amount
of programming can also be done using a Touch-Tone set locally or by
calling into the module.
This module can also be used to transfer a database to the ProTalk Link if
the internal cell phone is registered with a data plan through the wireless
carrier. See the LINK.EXE pc application's Help section for details on
using this feature.
Connectors
Refer to Figure 24 below for details of the connector pinouts.
ALARM OUTPUT
2 3 4 5 6 7 8 1 2 3 4
OUTPUT 1 OUTPUT 2
7 8
Figure 23 W1 Module Front Panel
Figure 24 W1 Module Connections
OUTPUT 3 OUTPUT 4
W1 INSTALLATION
B1285-W1