uuIndicatorsu
Indicator
Name
System Message
Indicator
Turn Signal and
Hazard Warning
Indicators
High Beam
Indicator
Lights On
Indicator
*1:Models with the smart entry system have an ENGINE START/STOP button instead of an ignition switch.
* Not available on all models
84
On/Blinking
Comes on for a few seconds when
●
you turn the ignition switch to ON
(
w
*1
, then goes off.
Comes on along with a beep when
●
a problem is detected. A system
message on the driver information
*
interface appears at the same time.
The turn signal indicators blink
●
when you operate the turn signal
lever.
If you press the hazard warning
●
button, both indicators and all turn
signals blink at the same time.
Comes on when the high beam
●
headlights are on.
Comes on whenever the light
●
switch is on, or in AUTO
the exterior lights are on.
Explanation
While the indicator is on, press the
●
(information) button to see the
message again.
Refer to the Indicators information in this
●
chapter when a system message appears
on the multi-information display. Take
the appropriate action for the message.
The multi-information display does not
●
return to the normal screen unless the
warning is canceled, or the
button is pressed.
Does not blink or blinks rapidly - A
●
turn signal light bulb has blown. Change
the bulb immediately.
2 Replacing Light Bulbs P. 512, 515
If you remove the key from the ignition
●
*
when
switch*, or set the power mode* to
VEHICLE OFF (LOCK) while the exterior
lights are on, a chime sounds when the
driver's door is opened.
Message
—
*
—
—
—
—