Wipers And Washers - Honda Fit 2018 Owner's Manual

uuOperating the Switches Around the Steering WheeluWipers and Washers

Wipers and Washers

■
Windshield Wiper/Washer
Adjustment Pull to
Ring * use
washer.
MIST
OFF
INT: Low speed with
intermittent
LO: Low speed wipe
HI: High speed wipe
*1 : Models with the smart entry system have an ENGINE START/STOP button instead of an ignition switch.
* Not available on all models
164
The windshield wipers and washers can be
used when the ignition switch is in ON
■
MIST
The wipers run at high speed until you release
the lever.
■
Wiper switch (OFF, INT, LO, HI)
Change the wiper switch setting according to
the amount of rain.
■
Washer
Sprays while you pull the lever toward you.
When you release the lever for more than one
second, the spray stops, the wipers sweep two
or three more times to clear the windshield,
then stop.
■
Adjusting wiper operation
Turn the adjustment ring to adjust the wiper
operation.
Lower speed, fewer sweeps
Higher speed, more sweeps
1Wipers and Washers
NOTICE
Do not use the wipers when the windshield is dry.
w ( *1 .
The windshield will get scratched, or the rubber
blades will get damaged.
NOTICE
In cold weather, the blades may freeze to the
windshield.
Operating the wipers in this condition may damage
the wipers. Use the defogger to warm the
windshield, then turn the wipers on.
Models with adjustment ring
If the vehicle speeds up while the wipers are
operating intermittently, the length of the wipe
interval shortens.
When the vehicle speeds up, the wiper operation's
shortest delay setting ( ) and the LO setting become
the same.
All models
*
Turn the washers off if no washer fluid comes out.
The pump may get damaged.