Muskoka 23-800-001 Use And Care Manual page 8

Operating Instructions (Continued)
5. Fahrenheit/Celsius Display:
This button displays F (Fahrenheit) or C (Celsius) depending on how the temperature mode is set. When the
fireplace is first turned on, the Fahrenheit (F) temperature will be displayed. To switch from Fahrenheit to Celsius,
or vise-versa, when HEATER is ON, hold HEATER CONTROL button for 10 seconds. The fireplace will remember the
last temperature mode setting, and in later use, the display will start at that setting, unless power to the unit has
been interrupted.
6. Temperature/Timer Display
This LED display shows the set point for the temperature and timer functions. When either of these functions is
activated, the display reflects the set point for five seconds and then fades to black. Any change in the set
point of the temperature or timer will reactivate the display, which again fades after five seconds.
The infrared remote control relies on a line of sight and must be pointed at the flame/screen of the fireplace to
work. The remote control unit has the controls required to turn ON/OFF both the main power and the heater.
If you prefer to use the touchpad control on the fireplace unit itself, open the control panel sliding cover to
access the touchpad buttons.The layout of the buttons on touchpads and remote control unit can be seen in
Figures 4 and 6, respectively.
1. Plug your fireplace into a 15-amp, 120-volt power outlet.
2. Turn the power on. Flame will show on the back screen of the
fireplace.
3. Remove plastic tab from inside battery compartment
to activate remote control.
4. Point the remote control directly at the fireplace
flame/screen and use the buttons to operate the
fireplace.
Battery Replacement Procedure: (Size CR2025)
Battery replacement instruction
Instructions de remplacement des piles
Instrucción de reemplazo de la batería
CR2025
OPEN
OUVRIR
ABRIR
PUSH
POUSSER
EMPUJE
RELEASE
RELÂCHER
LIBERAR
1. Main Power Button:
This button supplies power to all the functions of the fireplace. The main power
button must be in the ON position, either from the remote or on the touch pad
for the functions to work.
2. Timer Button:
This button controls the timer ON/OFF and 10-time setting from 30 minutes to 9
hours. When the Timer is first turned on, it will come on at the shortest time setting
(30 minutes). Each time the Timer button is pressed, the time increases 1 hour, up
to the longest setting (9 hours). Once the set time expires, all fireplace functions
will be automatically turned off.
3. Flame Control button:
This button controls the brightness of the flame effect with settings at High,
Medium and Low. When the fireplace is first turned on, the flame will come on
at the highest setting. The fireplace will remember the last flame setting used
and in later use the flame brightness will start at that setting, unless power to
the unit has been interrupted. Each time the Flame button is pressed, the flame
brightness decreases. The only way to turn off the flame effect completely
is to turn off the Main Power button.
8
Figure 5
The plastic tab inside the battery
compartment MUST be removed
before remote control will operate.
(Pull tab)
Figure 6
1
2
3
4