Installation - Muskoka 23-800-001 Use And Care Manual

Preparation
Before beginning assembly of product, make sure all parts are present. Compare parts with package contents
list and hardware contents. If any part is missing or damaged, do not attempt to
assemble the product. Contact customer service for replacement parts.
Open the unit and check carefully for visible damage. If you have any problems with installation,
operation, missing parts, or damage,please call 877-447-4768 for service.
DO NOT dispose of packaging until you are satisfied with your fireplace.
DO NOT return unit to store before calling 877-447-4768 for service.

Installation

The Fireplace should be located in an area:
• Out of direct sunlight
• Not susceptible to moisture
• Away from uninsulated outside wall
• At least 3 ft. (.9 m) from drapery, furniture and other combustibles
1. Place the assembled mantel near a 15-amp, 120-volt grounded electric outlet.
Read all instructions before using this appliance.
2. Place the insert directly in front of the mantel opening.
3. Carefully lift the insert through the center opening in the front of the fireplace. The bottom of the insert has
two foam rubber strips to prevent scratching of the hearth base. Slide the insert back through the opening
until the metal trim makes contact with the front of the mantel.
4. Install the mounting brackets provided with the insert in the pre-drilled holes on the bottom of the
insert (see Figure 2).
5. Carefully position mantel with installed fireplace against wall.
6. Plug the power cord into the 15-amp, 120-volt outlet. Use an extension cord rated for a minimum of 1,875
watts if necessary.
NOTE: This unit comes equipped with a safety switch on the back panel which disables the heater (See Figure 3).
To enable the heater, please ensure the switch is in the "On" mode. The heater will function using the remote
control or control panel on the front of the unit.
NOTE: This unit comes equipped with a safety switch on the back panel which disables the heater (See Figure 3).
To enable the heater, please ensure the switch is in the "On" mode. The heater will function using the remote control
or control panel on the front of the unit.
CAUTION: Make sure that the unit is installed so that the power cord is not compressed against or caught on
the unit or the mantel and that it has an unobstructed path to the grounded outlet.
Figure 2
6
Estimated Assembly Time: 15 minutes
Phillips Screwdriver (not included)
ets
Mounting Brack
Clearance to Combustibles
Sides 2-27/64 in. (61.5 mm)
Floor 0 in. (0 mm)
Top 2 in. (51 mm)
Front 36 in. (914 mm)
Rear 25/32 in. (20 mm)
Wooden Facing
[up to 5/8 in. (16 mm) thick]
5/16 in. (8 mm)