Setting The Speakers' Channels; Step 5: Setting Language Preference - Philips - MX3950D Manual

Setting the speakers' channels

You can adjust the delay times (center and
surround only) and volume level for individual
speakers. These adjustments let you optimize
the sound according to your surroundings and
setup. Speaker settings are only active on Multi-
channel audio outputs.
Digital Output
Night mode
Analog Output
Speakers
Speaker Layout
PCM Output
Set Speaker Settings
Front L & R
Center
Surr L & R
Sub Woofer
OK to exit
1
Press SURR. (or SURROUND on the front
panel) repeatedly to select 'Multi-channel'.
2
In disc mode, press SYSTEM MENU.
3
Select icon and press 4.
4
Use the joystick (1 2 3 4) on the remote to
navigate in the menu.
Move to and press 2.
Move to 'Speakers' and press 2.
5
Press 3 4 to select (Front L&R, Center,
Surr L&R, Sub Woofer), then press 2 to enter
the speaker setting menu.
➜
The test tone will be automatically
generated.
6
Use 3 4 to adjust the settings for each
speaker to suit your surround sound needs.
These adjustments may include :
A Turning on or off the sound output.
B Delay time settings - use the longer delay
settings when the surround speakers are
closer to the listener than the front speakers.
C Adjusting the volume levels for one or both
speakers until the sound evens.
7
Press OK to confirm.
To remove the menu
Press SYSTEM MENU.
pg 001-044_MX39-37-Eng1
Personal setting ...
On 3 ms
3 dB 6 dB
A B C
1
2
3
4
5
6
7
21
Getting Started
Step 5: Setting language
preference
You can select your preferred language settings
so that this DVD system will automatically
switch to the language for you whenever you
load a disc. If the language selected is not
available on the disc, the disc's default setting
language will be used instead. Except the DVD
system's Menu Language, it will remain once
selected.
SETUP MENU
Parental Control
Password
Menu Language English
Français
Defaults
Audio Language
Subtitle
Disc Menu
Go to language setup page
In disc mode, stop playback and press SYSTEM
MENU.
Select icon and press 4.
Use the joystick (1 2 3 4) on the remote to
navigate in the menu.
Move to and press 2.
Move to 'Menu Language' and press 2.
Select a language and press OK.
Use the joystick (1 2 3 4) on the remote to
navigate in the menu.
Move to and press 2.
Move to one of the following and press 2.
– 'Audio Language' (disc's soundtrack)
– 'Subtitle' (disc's subtitles)
– 'Disc Menu' (disc's menu)
Select a language and press OK.
5 6
Repeat steps ~ for other settings.
To remove the menu
Press SYSTEM MENU.
2/25/03, 9:57 AM
English
English
English
21
3139 115 21993