Sharp AL-10PK Service Manual page 5

AL-1041
4) Fit the projections of the cabinet to the notches of the
machine, push the cabinet downward a little and then slide
it in the direction indicated by the arrow.
5) Secure the cabinet cover using the screw which has been
removed.
6. Connecting the power cord
1) Ensure that the power switch of the copier is in the OFF
position. Insert the removed power cord into the power cord
socket at the rear of the copier.
7. Connecting the interface cable
To use an AL-1000 series machine as a laser printer, connect
it to the parallel interface cable.
Use the supplied parallel interface cable.
For specifications of the parallel interface, see page 5-1.
1) Check that the power switches of both the printer and the
computer are in the OFF position.
2) Plug the parallel interface cable into the printer interface
connector. Fasten the two bail clips at the side of the printer
connector to hold the interface connector in place.
3) Plug the other end of the cable into the parallel interface
connector on your computer. (Refer to your computer
manual for details.)
Bail clip
The printer sends and receives data bi-directionally and
at high speed. Some switch boxes and pass-through
devices cannot support high-speed, bi-directional trans-
fer of data, and using them may cause printing errors.
3-3
Parallel interface connector
Interface connector
Cable