8-2 Operating Steps
1 Control Panel Explanation
HIGH TEMP
FILL WATER
ECONOMY MODE
HYBRID MODE
E-HEATER MODE
TIME ON
TIME OFF
ON\OFF
CANCEL
TIME
CLOCK
ON
2 Display Explanation
①
②
FILL WATER
HIGH TEMP
16
ECONOMY MODE
15
HYBRID MODE
14
E-HEATER MODE
TIME ON
TIME OFF
13
12
11
Table.8-5
HIGH TEMP indicator: When the setting temperature
①
exceeds
50℃, this indicator will illuminate..
FILL WATER indicator: When the power supply is turned
②
on,
it illuminates to remind you to refill water if necessary.
ALARM indicator: It will flash due to a malfunction or
③
protection.
TEMP-SET indicator: Shows error code if there is a problem
④
and displays the pre-set target temperature at other times.
⑤
LOCK indicator: Illuminates when display is locked.
Water temperature indicator: Illuminates when the actual
⑥
water temperature exceeds
Water temperature indicator: Illuminates when the actual
⑦
water temperature exceeds
Display
TEMP-SET
ALARM
LOCK
OUTLET TEMP
TIMER
CONFLICT
Operation
MODE
TIME
OFF
Fig.8-3
③
④
⑤
TEMP-SET
ALARM
LOCK
OUTLET TEMP
⑥
⑦
⑧
TIMER
CONFLICT
⑩
⑨
Fig.8-4
60℃.
50℃.
Water temperature indicator: Illuminates when the actual
⑧
water temperature exceeds
OUTLET TEMP indicator: Displays water temperature of
⑨
the upper part of the tank.
TIMER CONFLICT indicator: Illuminates when the
⑩
temperature set through Wired Controller conflicts with
that through display.
TIME OFF indicator: Illuminates when time off mode
11
has been set.
TIME ON indicator: Illuminates when time on mode
12
has been set.
CLOCK indicator: Display present time, blanks
13
when screen protection is activated.
E-HEATER MODE indicator: Illuminates when user sets
14
the E-heating Mode.
HYBRID MODE indicator: Illuminates when user sets the
15
Hybrid Mode.
ECONOMY MODE indicator: Illuminates when user set the
16
Economy Mode.
3 Operation Panel
Used to turn the
Used to cancel
unit on or off
timer and lock
ON\OFF
CANCEL
TIME
CLOCK
ON
Used to set
Used to set the
time
ON timer
4 Operation Instruction
Preparation before running the unit.
When you turn on the power supply, all the indicators on the
display will light for 3 seconds, the buzzer will sound and
then display the preset screen. After no operation
for 1 minute, all indicators will go out automatically except
for the Fill Water indicator flashing and tank temperature
indicator. Buzzer will sound when you press it.
When the tank is full, press the ON\OFF key, the Fill Water
indicator will stop flashing and you can continue to set other
settings. When all settings have been finished,
ON\OFF key again and the Fill Water indicator will go out. Then
unit can operate.
When the unit is in operation, if there is no operation or
malfunction for 20 seconds, the backlight of the display will go
out automatically except lights for the operation mode, outlet
temperature and lock indicator .
40℃.
Used to increase
Used to set
time or temp.
different modes
MODE
TIME
OFF
Used to decrease
Used to set the
time or temp.
OFF timer
Fig.8-6
press the
Installation & Owner's Manual
13