1. ENTERING TO DESIGN MODE
1) Select the Service mode.
(See page 6)
When QA02 is initialized, items "OPT" and "OPT1" of DESIGN MODE are set to the data of the representative model of this
Therefore, because ON-SCREEN specification remains in the state of the representative of model. This model is required to
reset the data of items "OPT" and "OPT1".
2. SELECTING THE ADJUSTING ITEMS
Every pressing of CH t button in the design mode changes the adjustment items.
(s button for reverse order)
3. ADJUSTING THE DATA
Pressing of ; -/+ button will change the value of data.
2) While pressing o(or CALL) button on the
remote controller and press MENU button
– 9 –
3) Press MENU button on TV.