Delsys TRIGNO User Manual page 7

FCC ID: W4P-SP-W01 (Trigno™ Sensor)
FCC ID: W4P-SP-W05 (Trigno™ Sensor)
This device complies with Part 15 of the FCC Rules and Industry
Canada's RSS-210 License Exempt Standards. Operation is sub-
ject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interfer-
ence received, including interference that may cause undesired op-
eration.
This product complies with FCC OET Bulletin 65 radiation expo-
sure limits set forth for an uncontrolled environment.
Pursuant to Part 15.21 of the FCC Rules, any changes or modifica-
tions to this product not expressly approved by Delsys Inc. might
cause harmful interference and void the FCC authorization to op-
erate this product.
To reduce potential radio interference to other users, the antenna
type and its gain should be so chosen that the equivalent isotropi-
cally radiated power (EIRP) is not more than that required for suc-
cessful communication.
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. There is no guaran-
tee that interference,will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into outlet on a separate circuit.
7
Trigno EMG System
TM