Installation; Transmitter Power Supply - Philips FM CORDLESS SPEAKER BC8210 User Manual

Fm cordless speaker
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
XP SBC BC 8210/00-1.1

Installation

Transmitter power supply

IMPORTANT
Use only Philips SBC CS030/00 12 Volt/
200 mA AC/DC adapter
1 Make use of the Philips SBC HC 8372 FM
wireless transmitter.This transmitter can be
purchased separately.
2 Make sure the adapter's rated voltage
corresponds to the mains socket voltage.
3 Connect the DC connector of the AC/DC
adapter to the 12 Volt DC power input
connector located at the rear of the
transmitter.
4 Connect the 12 Volt/200 mA AC/DC
adapter to the mains socket.
– Always disconnect the AC/DC adapter if
the transmitter is not to be used for a
long period of time.
Speaker power supply
IMPORTANT
Use only rechargeable LR6/AA NiCd
batteries (preferably Philips).
Do not use alkaline batteries as
these may damage your FM wireless
system!
Environmental Information
All redundant packing material has been omitted.We have done our best to make the
packaging easily separable into two materials: cardboard and polyethylene
Your unit consists of materials which can be recycled if disassembled by a specialized
company. Please observe the local regulations regarding the disposal of packing
materials, exhausted batteries and old equipment.
6
20-08-2001 13:43
1 Remove the isolating sheet from the
2 Check if the power button of the
3 When the sound quality of the FM speaker
4 Make sure the adapter's rated voltage
5 Connect the DC connector of the AC/DC
6 Connect the 9 Volt/500 mA AC/DC
Pagina 6
battery compartment.
FM speaker is in the on position.
degrades, it indicates that the batteries are
running low.
– To recharge the speaker's built-in
rechargeable LR6/AA NiCd batteries,
connect to the 9 Volt/500 mA AC/DC
adapter.
corresponds to the mains socket voltage.
adapter to the 9 Volt DC power input
connector located at the rear of the
speaker.
adapter to the mains socket.
Notes:
Completely flat batteries need approximately
16 hours to recharge.
Always remove the batteries if the speaker
is not to be used for a long period of time.
Batteries contain chemical substances,
so they should be disposed of properly.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sbc bc8210

Table of Contents