Advertisement
TV2 Room Pressure Monitor Quick Start Guide
1.
The Care and Use guide for your TV2 Room Pressure Monitor can be downloaded here:
www.e2di.com/usersguides.html
Although you should use the Users Guide to familiarize yourself with the TV2 installation
and use, you can use the quick-start instructions below, if you are in a hurry.
Your TV2 room pressure monitor comes with free software to copy the logged data from your TV2
to your computer. To download the free TView software go to
www.e2di.com
and click on TView 6.3 link Room Pressure Monitor Software, copy the software to
your desktop, unzip it and click on 'Setup' to install.
Temperature/RH Sensor
P O Box 159 • Crestwood, KY 40014 • (502) 243-0042 • (502) 243-0039 fax
Please print out the Users Guide.
TV2 sensor sockets
www.e2di.com
info@2di.com
•
the download page under support at
Pressure Sensor
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for TWO DIMENSIONAL INSTRUMENTS TV2
- Page 1 Your TV2 room pressure monitor comes with free software to copy the logged data from your TV2 to your computer. To download the free TView software go to the download page under support at www.e2di.com...
- Page 2 QUICKSTART Your TV2 can be installed and operating in just a few minutes by following these simple steps. 1. Connect the USB cable to a PC or wall plug and the System Parameter display will appear. 2. Touch ‘Up’ or 'Down' to select C° or F° and touch ‘Enter’.
- Page 3 Setting up sensors 1. Plug the pressure sensor into the socket next to the small green relay on the end of the TV2 display and the temp/RH sensor next to it. Position the pressure sensor so that the positive and negative clear plastic tube openings are in different rooms to see the pressure differential.
- Page 4 Setting the sensor alarms 5. Set Alarms, if needed, by highlighting the ‘Set Alarm’ button on the Sensor Setup screen with 'Left' or 'Right' and touching ‘Enter’. 6. Enable the alarm by touching 'Up' and then 'Enter'. 7. Set the trigger-alarm-time to any value between 0:00 and 99:00. This controls how long the audible alarm and the relay will be activated.
- Page 5 QuickCheck The QuickCheck screen indicates the safe/unsafe condition of room pressure, temperature and humidity at all times. If all the numbers are green the room is safe, but if any of them appear red the clean room should not be used that condition is corrected. Condition If Green If Red...
- Page 6 If the Minimum pressure setting is red the pressure dropped below the safe conditions at some point in the past. As long as the current pressure is green it is ok. Check the logged data to see what happened If the Alarm is disabled the quick check will be unable to display red conditions.
Need help?
Do you have a question about the TV2 and is the answer not in the manual?
Questions and answers