Connecting Sea Cylinders - Apewell SCS-8 Operation Manual

4. Connect the SEA cylinders to the fill adapter hoses.
a. Remove the dust cap from the fill port of
the SEA.
b. Install the male quick coupler fitting into
the fill port until the o-ring is fully seated---
this normally takes only finger
pressure however you can use gentle pres-
sure with a wrench if desired.
c. Pull the collar back on a female quick
connector and insert the male until they are
fully mated.
d. Place the SEA into the
cylinder holder tube.
Capewell Aerial Systems LLC
SCS-8 - Operations Manual
Page 4