Philips GC3580 SERIES User Manual page 13

Problem
EN
The iron is
plugged in, but the
soleplate is cold.
The iron does not
produce any
steam.
The iron does not
produce a
steam boost.
Water droplets drip
onto the fabric
during ironing.
Possible cause
The temperature
dial is set to MIN.
There is not enough
water in the water
tank.
The steam control is
set to position .
The iron is not hot
enough.
You have used the
steam boost function
too often within a
very short period.
The iron is not hot
enough.
There is not enough
water in the water
tank.
You have not closed
the cap of the filling
opening properly.
You have put an
additive in the water
tank.
The set temperature
is too low for steam
ironing.
You have used
the steam boost
function at a
temperature setting
below 3.
Solution
Set the temperature dial to
the required position.
Fill the water tank (see
Set the steam slider to
position or . (see
Set an ironing temperature
that is suitable for steam
ironing (2 to MAX). Put
the iron on its heel and wait
until the temperature light
has gone off before you start
ironing.
Continue ironing in horizontal
position and wait a while
before you use the steam
boost function again.
Set an ironing temperature
at which the steam boost
function can be used ( 3 to
MAX). Put the iron on its heel
and wait until the temperature
light has gone off before you
use the steam boost function.
Fill the water tank (see
Press the cap until you hear
a click.
Rinse the water tank and do
not put any additive in the
water tank.
Set a temperature of 2 or
higher.
Set the temperature dial to a
setting between 3 and
MAX.
).
).
).
13