Cisco TelePresence Precision 60 Manual page 6

Cisco TelePresence Precision 60 and SpeakerTrack 60
Contents
Precision 60
Video
• HDMI is the main video source. The maximum resolution
is 1080p60.
• 3G-SDI is the secondary video source. The maximum reso-
lution is 1080p60.
• In multiple camera scenarios, the HDMI output should be used.
• For long cable lengths, HDMI extenders supporting EDID
should be used. The extender must not alter the SPA address
or any EDID information incorrectly.
Power
• Connect power (12 V , 2.5 A).
DC
• Always use the provided cables and adapter.
Ethernet
For camera control and software upgrades.
Do NOT connect a camera control cable to the Ethernet
codec port of the device. This will destroy the system.
Kensington lock
The Kensington lock may be used to prevent the camera from
being moved from its place or to prevent theft.
D15296.03 Cisco TelePresence Precision 60 and SpeakerTrack 60, APRIL 2016.
Introduction Physical interface Physical interface
3G-SDI out
Connecting the camera
Display port*
HDMI Video Pin-hole for
out factory reset
6
Factory reset Appendix
Ethernet
RJ45
Kensington lock Power
supply
The LED is lit during a call.
The LED is continuously lit when power is
On, and flickers when receiving signals
from the remote control.
Copyright © 2016 Cisco Systems, Inc. All rights reserved.
Camera guide
* For future use