Unimig P1004 Operating Manual page 7

-Install the P1004 blower on the belt.
Remove the release buckle out of the belt. FIGURE 3(A).
Draw the fasten belt out from the waist connector. FIGURE 3(B)
Slide the fasten belt into the blower unit through the two blower slots. FIGURE 3(C).
Slide the fasten belt back into the waist connector. FIGURE 3(D).
Put the release buckle back into the belt. FIGURE 3(E).
Adjust the belt tightness so it can fit well with your shoulder and waist. FIGURE 3(F).
NOTE: Check that the belt is securely fastened.
Figure 2 (B)
Figure 3 (A)
Figure 3 (C)
Figure 3 (D)
Figure 3 (E)
Figure 3 (E)
Figure 3 (B)
7