Mounting The Chassis To The Case Assembly; The Nuts Of The Volume Knob And Channel Knob; Attaching The Antenna Receptacle To The Chassis - Kenwood TK-D240 Service Manual

3.2.4 Mounting the Chassis to the Case Assembly

(1) Confirm that the waterproof packing attached to the cir-
cumference of the chassis is securely inserted in the
groove of the chassis <1>.
(2) Insert the upper part of the chassis into the case assembly
<2>.
(3) Press the chassis <3> and the case assembly together to
attach them.
Caution:
If the packing of the SP/MIC is not at the correct position
after attaching the chassis to the case assembly, reposi-
tion the packing with your fingers.
<3> <3>
<3> <3>

3.2.5 Attaching the Antenna Receptacle to the Chassis

Screw the antenna receptacle to the chassis in the order shown
in the drawing so that the antenna receptacle comes to the cen-
ter of the case hole.
Tighten this screw second.
1-18 (No.RA035<Rev.001>)
<1>
<2>
Tighten this screw first.

3.2.6 The Nuts of the Volume Knob and Channel Knob

Note that the shape, color and height of the nuts of the volume
knob and channel knob are different from one another. (The nut
of volume knob is silver, and the nut of channel knob is gold.)
Use the following jig when removing the nuts of the volume knob
and channel knob:
• Jig (Part No.: W05-1012-00)
for Volume knob
(Long)
for Selector knob
(Short)