Table of Contents
Advertisement
© National Instruments Corporation
Consult the documentation for your SCXI chassis and other SCXI modules
for additional instructions and warnings. Any non-SCXI-1127 modules
should already be installed according to their installation instructions. To
set up the SCXI-1127 module to be accessed by a DAQ device via another
SCXI module, follow these steps while referring to Figure 1-9.
1.
You should have already installed the SCXI-1127 modules and their
HVAB-backplane adapters (1357/1358) according to the instructions
found earlier in this chapter.
2.
Connect the MIO/DIO cable adapter to the rear of a module that is not
the SCXI-1127 module. Secure the adapter to the SCXI chassis using
the screws provided.
3.
Attach your DAQ cable to the cable adapter at the rear connector.
4.
Attach the other end of the DAQ cable to the National Instruments
DAQ device.
5.
Check the installation.
6.
Turn on the SCXI chassis.
7.
Turn on the computer or reconnect it to your chassis.
8.
If you already have the appropriate software installed, you are ready to
configure the SCXI-1127 via an SCXI module other than the
SCXI-1127 module.
Chapter 1
Installing and Configuring the SCXI-1127
1-17
SCXI-1127 User Manual
Advertisement
Table of Contents
