On The Airplane; Devices Of Other Manufacturers; Maintenance; Non-Ionic Radiation - Cyrus CM6 Manual

1. SAFETY AND PERFORMANCE
The electronic system of the vehicle, such as ABS, speed control and injection systems,
are generally not affected by radio waves. The manufacturers of this type of equipment
can provide information on whether these devices have a good shielding function. If you
assume radio waves have caused a car damage, please contact your dealer. Do not start
up without prior inspection by a qualified technician.

1.6 ON THE AIRPLANE

Please turn the phone off when you are on the aircraft or near an airplane. It is illegal to use
a mobile phone on the aircraft; it could lead to dangerous aircraft disturbances, or even
disturb mobile radio networks.
» In an emergency, the telephone can be used following compliance with the safety
regulations and the permission of the crew.

1.7 DEVICES OF OTHER MANUFACTURERS

Use of non - approved equipment, cables, or accessories from other manufacturers may
void the warranty of the phone, and will also affect the normal use of the mobile phone.
Please be sure to use the cables provided for this phone.

1.8 MAINTENANCE

There are no parts inside the mobile phone, the battery, and charger that can be repaired
by the user. It is recommended that you send your mobile phone to the designated repair
shop.

1.9 NON-IONIC RADIATION

Mobile telephones should be connected to the antenna by means of non-radiating
cables such as coaxial cables. The antenna should not come close to the human body,
unless both are protected by a metal shield, such as metal roof. You can only use an
antenna specially designed for the mobile phone. Use of non-approved antennas,
unauthorized modifications or additions may damage the phone or violate the applicable
regulations. This can lead to a reduced power or to the fact that the radiation quantity
does not correspond to the standard.
11

1.10 EFFECTIVE USE

Please observe the following guidelines in order to achieve the best performance with
minimum power consumption: Do not cover the position of the built-in antenna during the
call; this can influence the conversation quality and lead to the mobile phone processing
more data than normal and thereby the call and stand by time of the battery may be
reduced.
1.11 HIGH FREQUENCY
Your mobile phone is a low-power radio receiver and transmitter. After start up, it transmits
and receives radio signals at regular intervals. The network system controls the trans-
mission power of the mobile telephone.
12