Table of Contents
Advertisement
5.4.2
Video output
The ▲▼ buttons are used to select the parameter. The ► button changes the value. The O key
confirms the selection. The following parameters may be set:
ASI output mode packet format - 188 / 204 / byte
DV1 output connector – SDI or ASI
DV2 output connector – SDI or ASI
AV1 output connector – CVBS or component Y (note AV2 connector is always component C
and cannot be switched)
5.4.3
Audio levels
This menu allows each of the 4 analog audios to be off-set from the nominal 0 dB line level output.
The setting of these values is reflected in the Status menu – see paragraph 5.3.2
The ▲▼ buttons are used to select the parameter. The ◄► button changes the value. The O
confirms the selection. The following parameters may be set:
Genlock status – Enable/Disable
Genlock reference type – SD Composite black sync or HD Tri-level sync
Genlock timing offset – H
Genlock timing offset - V
5.5
Remote control
The Ethernet port on the rear of the unit, allowing remote control of the RFX-HD-D, is currently a
.
future option
RFX-HD-D
Operator's Manual
Last Rev: July 2008
RF ExtremeCare: 866.732.0113
11
Advertisement
Table of Contents
