Summary of Contents for RF Central RFX-HD-D
- Page 1 RFX-HD-D MPEG2 ASI Decoder OPERATOR’S MANUAL Copyright 2008 RF Central Need help? Contact Technical Support: 866.732.0113 (866.RFC.0113) RFX-HD-D Last Rev: July 2008 Operator’s Manual RF ExtremeCare: 866.732.0113...
-
Page 2: Table Of Contents
......................11 EMOTE CONTROL MAINTENANCE........................13 The information contained in this document remains the property of RF Central and may not be used, disclosed, or reproduced in any other form whatsoever without the prior written permission of RF Central. RF Central reserves the right to alter the equipment and specifications pertaining to the equipment described in this document without notification. -
Page 3: General Safety Information
CAUTION : This system contains MOS devices. Electro-Static Discharge (ESD) precautions should be employed to prevent accidental damage. CAUTION - AC supply connection and protective earth. The RFX-HD-D is a Class 1 device and when used with an AC supply must be connected to a ground. Installation should always follow local wiring regulations. -
Page 4: Introduction
2 INTRODUCTION The RFX-HD-D is a stand alone ASI decoder for SD / HD MPEG2 digital video. The unit accepts ASI DVB transport stream at the input, decodes the signal according to MPEG2 profiles, and outputs 1 video plus the associated audios. Output formats include:- •... -
Page 5: Specifications
Environmental To spec: 32° F to 113° F Altitude: 14764 ft. Humidity: 95% long term Specifications may alter at the discretion of RF Central or to meet customer specific requirements. RFX-HD-D Last Rev: July 2008 Operator’s Manual RF ExtremeCare: 866.732.0113... -
Page 6: Electrical Interfaces
Digital Video Outputs (2) Connector Type: Independently selectable to output ASI or SDI by front panel menu control When selected to SDI, provides HD or SD SDI (depending on input signal) RFX-HD-D Last Rev: July 2008 Operator’s Manual RF ExtremeCare: 866.732.0113... -
Page 7: Analog Video Output(S)
Phoenix, 5 way MCV1.5 series 2 analog audio outputs. Balanced 600 Ohms pin 1 Audio 1 pin 2 Audio 1 pin 3 Audio GND pin 4 Audio 2 pin 5 Audio 2 RFX-HD-D Last Rev: July 2008 Operator’s Manual RF ExtremeCare: 866.732.0113... -
Page 8: Analog Audio Output(S) 3 And 4
Audio 4 pin 5 Audio 4 4.1.8 Ethernet Connector For remote control (future option) 4.1.9 AC Power Input Connector Type: 110 / 230 VAC input, with On / Off switch RFX-HD-D Last Rev: July 2008 Operator’s Manual RF ExtremeCare: 866.732.0113... -
Page 9: Configuring The Receiver
Delay mode, auto detected - Standard or Ultra Low Delay − ASI output packet format – 188 / 204 / byte modes − Analog video output, set to either CVBS or Y/C RFX-HD-D Last Rev: July 2008 Operator’s Manual RF ExtremeCare: 866.732.0113... -
Page 10: Current Status (2 Of 3)
The following parameters may be set Genlock status – Enable/Disable Genlock reference type – SD Composite black sync or HD Tri-level sync Genlock timing offset – H Genlock timing offset - V RFX-HD-D Last Rev: July 2008 Operator’s Manual RF ExtremeCare: 866.732.0113... -
Page 11: Video Output
Genlock reference type – SD Composite black sync or HD Tri-level sync Genlock timing offset – H Genlock timing offset - V Remote control The Ethernet port on the rear of the unit, allowing remote control of the RFX-HD-D, is currently a future option RFX-HD-D Last Rev: July 2008 Operator’s Manual... -
Page 12: Settings Menu
SDI out AV1 out: CVBS Audio level settings menu Audio 1 level 0.0dB Audio 2 level 0.0dB Audio 3 level 0.0dB RFX-HD-D Audio 4 level 0.0dB Status and configuration menu RFX-HD-D Last Rev: July 2008 rator’s Manual RF ExtremeCare: 866.732.0113... -
Page 13: Maintenance
6 MAINTENANCE The RFX-HD-D incorporates miniature circuit design with surface mount components and is not suitable for maintenance by the operator. In the event of maintenance being required, please contact RF Central ExtremeCare Customer Support at 866.732.0113 for technical assistance.