Harley Benton GA-212 R Owner's Manual page 5

GA-212 R
LOW:
f
MID:
g
HIGH:
h
LED:
j
VOLUME:
k
REVERB:
l
CD/LINE INPUT: Sockets for connection of external CD play.
1(
INSERT:
2)
FOOT SWITCH: A 1/4" 2 conductor jack that allows the channels to be
2!
POWER:
2@
Rear panel
AC Line socket
2#
LOUDSPEAKER: Connect your loudspeakers here. The impedance of the
2$
FX SEND:
2%
FX RETURN:
2^
between them.
Adjusts the amount of boost or cut (+/-12db) in the low
frequency range (150Hz).
Adjusts the amount of boost or cut (+/-12db) in the
middle frequency range (600Hz).
Adjusts the amount of boost or cut (+/-l2db) in the mid-
high frequency range (5kHz).
This LED lets you know you are using channel two.
The overall volume level of channel two.
Adjusts the amount of reverb on both channels.
A 1/4" 3 conductor jack allowing inserting an external
effects device such as a chorus or delays into the signal
chain. Both input and output are on the same jack.
switched back and forth for soloing or a special effect.
The on/off switch provides electrical power to the unit.
This inlet is grounded and must NEVER have the ground
pin removed for any reason.
Build-in Fuse: Replace only with the same type of fuse.
cabinet's should not be less than 4 Ohms. Connecting
cabinets that have a lower impedance than 4 Ohms will
result in the amplifier overheating. Continual use in this
manner may cause permanent damage.
This socket is provided for connecting an external
device. The output from this socket should be connected
to the external devices input.
Use this socket to feed the processed signal from the
external device back into the amp.
5