Valor BR622 Owner's Manual page 6

battery may need replacing. Details of battery
replacement are given further on in this
manual.
Until you can obtain a replacement battery the
fire can be lit with a taper as described later in
the instructions.
2. Keep the button at the ignition position for a
further ten seconds. This
flame sensing device from shutting off the gas
while its probe warms up as explained on the
previous page.
3. If low heat is required, release the button. The
button will automatically spring up to the low
heat position shown in figure 2 (See note i
below).
4. For a higher heat level slide the button
upwards. The burner flames and heat output
will gradually increase until the button reaches
the high heat position shown in figure
figure 2
FireSllde
When the button reaches the high heat
position you will feel a check to its movement.
Do not slide the button above the high heat
position unless you want to turn the fire off
(See note below).
i
Note
i) If the flames go out while setting the
control, repeat the full lighting procedure. If
the flames repeatedly go out have the fire
serviced.
Please note. When first turned on the
ii)
I
USERS INSTRUCTIONS
will prevent the
2.
Off
J-Hgh
heat
Slide
control
button
Low
heat
"--------Ignition
Control
flames will appear predominantly
coals will take time to warm
some glow will be seen after approximately ten
minutes, the full visual effect will only be
apparent after a somewhat longer time.
iii) The appliance will operate to its maximum
potential if the flue is primed during the first
20 - 30 minutes of operation.To do
slide the control button to its highest
This will also burn off any carbon deposits that
may have formed during previous
iv) If operating the appliance
it is beneficial occasionaly to change the
settings. This will also help to remove any
carbon deposits that may form during
operation.
figure 3
Lighting with a taper
(Shown with "Adorn" front)
To turn the fire off
Slide the button up past the high heat
to the "0" position.
Both the main burner and the pilot should go
out. While cooling,
crackling noises.
lighting with a taper (see figure 3)
In the unlikely event of failure of the ignition
spark, the pilot
spill. Insert the
left side wall of the fire box and operating the
slide control as
Page 6
blue.
up. Although
this,
operations.
for long periods
.,
\~"~
the coals may make some
This is quite normal.
can be lit by a taper or long
taper or spill alongside of the
described above.
The
simply
setting.
position