Test Mode - Sony XTL-75V Service Manual

Test mode setting
[OPEN/CLOSE]
1. Press the
[V ADJ]
2. Press the button and
neously.
3. A beep sounds and the test mode is activated.
Note: The test mode is active for several seconds only, and it returns to
normal state if no operation is performed during this time. When
the test mode is activated, perform the following operation imme-
diately.
Monitor position initializing
Return the position and angle at the time of monitor open state to
the initial position set in the factory.
1. Immediately after the Test mode is activated, press the
[SEARCH --]
button and
sound)
2. Press the RESET button, and the monitor is stored and the
monitor position is initialized. (Normal state will get back)
10
SECTION 4

TEST MODE

button to place the set in open state.
[TV/VIDEO]
button simulta-
[TV/VIDEO]
button. (A beep will