Table of Contents
Advertisement
PRECAUTION ON HANDLING THE SET
During the manufacturing of this set, the slide gear phase has been
finely adjusted.
Therefore, never remove those screws shown in the figure when
making repairs.
two screws
HOW TO PULL UP THE MONITOR BY HANDS AT POWER OFF
1. Draw out the front panel fully in the direction of the arrow 1,
and remove the shaft (stopper) from the monitor.
2. Push the slider knob (L) and slider (R) in the direction of ar-
row 2.
(Meshing of gear (slide L) – monitor gear (L), and gear (slide
R) – monitor gear (R) can be disengaged)
3. Pull up the monitor in the direction of arrow 3.
monitor gear (L)
gear (slide L)
slider knob (L)
slider knob (L)
four screws
monitor
2
1
front panel section
three screws
shaft
(stopper)
3
slider knob (R)
screw
monitor gear (R)
gear (slide R)
slider knob (R)
3
Advertisement
Table of Contents
