Tait TM8000 Service Manual page 20

6.
Important
7.
Important
8.
9.
20
Screw the external options connector to the radio lid using the two screw-
h
lock fasteners .
Tighten the fasteners to a torque of 0.9N·m (8lbf·in).
The external options connector screw-lock fasteners must be
tightened correctly before screwing the universal line interface
board onto the mounting posts
Screw the universal line interface board to the mounting posts on the radio
lid using six M3x8 self-tapping screws
Tighten the M3x8 screws to a torque of 1.9N·m (17lbf·in)
For the universal line interface board to be installed correctly in
the radio's options cavity, the internal options connector loom
must be looped in the way shown in the diagram.
Plug the unattached end of internal options connector loom
internal options connector on the radio main PCB.
Refit the radio lid and top cover to the radio and screw the external options
1!
cover seal over the external options connector, using the two 4-40x3/16
1@
screws .
i
.
j
.
TA2922 Universal Line Interface Service Manual
© Tait Electronics Limited March 2010
1)
1)
into the