Get Started; Prepare The Remote Control; Turn On; Install Radio Stations Automatically - Philips FXD58 User Manual

4 Get started

Caution
•
Use of controls or adjustments or performance of
procedures other than herein may result in hazardous
laser exposure or other unsafe operation.
Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for the
model and serial number of this apparatus. The
model number and serial number are on the
back of the apparatus. Write the numbers here:
Model No. __________________________
Serial No. ___________________________

Prepare the remote control

1
Press and push the battery compartment
to slide it open (see "1" in the illustration).
2
Insert one AAA battery with correct
polarity (+/-) as indicated.
3
Push and slide back the battery
compartment (see "3" in the illustration).
Note
•
The battery shall not be exposed to excessive heat
•
If you are not going to use the remote control for a
long time, remove the battery.
•
Batteries contain chemical substances, so they should
be disposed of properly.
EN
14

Turn on

• Press .
» The unit switches to the last selected
source.
Switch to standby mode
• Press again to switch the unit to standby
mode.
» The backlight on the display panel
turns off.
Install radio stations
automatically
When you connect power and no radio
stations are stored, the unit automatically begins
to store radio stations.
1
Connect the unit to power supply.
» [AUTO FM INSTALL - PRESS PLAY--
STOP CANCEL] (auto FM install
- press PLAY to start - press STOP to
cancel) is displayed.
2
Press to start installation.
» [AUTO] (auto) is displayed.
» The unit automatically stores radio
» When all the available radio stations
is broadcast automatically.