Make Electrical Connections-Direct Wire Method; Make Electrical Connections-Power Supply Cord Method - Whirlpool GU3100XTVB Installation Instructions Manual

Make Electrical Connections—Direct
Wire Method
Check "Electrical Requirements" section before beginning.
Ensure that the electrical installation is adequate and in
conformance with all national and local codes and ordinances.
WARNING
Electrical Shock Hazard
Electrically ground dishwasher.
Connect ground wire to green ground connector in
terminal box.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
1. Route the direct wire so that it does not touch the dishwasher
motor or lower part of the dishwasher tub.
2. Pull the direct wire through the hole in the terminal box.
3. Using twist-on connectors sized to connect direct wire to 16-
gauge dishwasher wire, connect the white wire from the
power supply to the white wire on the terminal box.
4. Using twist-on connectors sized to connect direct wire to 16-
gauge dishwasher wire, connect the black wire from the
power supply to the black wire on the terminal box.
5. Using twist-on connectors sized to connect direct wire to 16-
gauge dishwasher wire, connect the ground wires from the
power supply to the green ground connector on the terminal
box.
A
A. White wire to white wire
B. Ground wires to green ground connector
C. Grounding screw
D. Black wire to black wire
6. Tighten the clamp connector or conduit connector screws.
7. Reinstall the terminal box cover with the wires inside terminal
box.
8. Check that no wires are pinched by the cover.
Make Electrical Connections—Power
Supply Cord Method
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Use Power Supply Cord Kit (Part Number 4317824) marked for
use with dishwashers. Kit contents include:
■ Voltex, Inc., UL listed 16 gauge 3-wire power supply cord with
3 prong grounding plug
■ Neer C-500 " strain relief
■ 3 wire connectors
■ Part No. 302797 grommet
Follow the kit instructions for installing the power supply cord.
NOTE: Power supply cord must plug into a mating three prong,
grounded outlet, located in the cabinet next to the dishwasher
opening. Outlet must meet all local codes and ordinances.
IMPORTANT: If you plan to install a garbage disposal, an
additional separate 120-volt, 60 Hz, AC-only, 15- or 20-amp
fused electrical supply is required.
1. Remove the terminal box cover.
B
C
D
13