General Instructions - Zhone zNID-GPON-2403 Hardware Installation Manual

General Instructions

•
Prevent direct exposure to optical fiber ends or optical connector ends
where laser signals are directly accessed. Do not handle pieces of optical
fiber with fingers. Use tweezers or adhesive tape to lift and discard any
loose optical fiber ends.
•
Wear rubber gloves to clean optical connectors. The gloves prevent direct
contact with the isopropyl alcohol and prevent contamination of the
ferrules with skin oils.
•
Place all optical fiber clippings in a plastic container provided for that purpose.
•
Handle optical fibers with caution. Place the optical fibers in a safe
location during installation.
•
Follow the manufacturer instructions when using an optical test set. Incorrect
calibration or control settings can create hazardous levels of radiation.
Other precautions to take before installing or servicing the product are as follows:
•
Never install telephone wiring during a lightning storm.
•
Never touch uninsulated telephone wires or terminals unless the
telephone line has first been disconnected at the network interface.
•
Use caution when installing or modifying telephone lines.
•
Only authorized service technicians can service this
product.Unauthorized service to this product can cause exposure to
dangerous high-voltage points or other risks and may result in injury or
damage to the unit and void all warranties.
•
Special cables, which may be required by the regulatory inspection
authority for the installation site, are the responsibility of the buyer.
•
When installed in the final configuration, the product must comply with
the applicable Safety Standards and regulatory requirements of the
country in which it is installed. If necessary, consult with the appropriate
regulatory agencies and inspection authorities to ensure compliance.
•
Install the zNID in accordance with national and local electric codes in order
to meet all applicable requirements. Consult a qualified electrical consultant.
Important Safety Instructions
zNID Hardware Installation Guide
13