Operation; Adjusting The Cutting Height - sunjoe MJ404E-360 Operator's Manual

Fig. 3
3. Lift the ejector flap with one hand. With the other hand,
hold the grass collection bag by the handle and hook it in
from above (Fig. 4).
Fig. 4
Ejector
flap

Operation

This lawn mower is intended for private residential use to cut
grass in small lawns and gardens. This lawn mower is not
intended to cut grass in public parks, playing fields, farms, or
forests. Do not use this lawn mower for any application other
than that for which it is intended.

Adjusting the Cutting Height

This electric lawn mower is equipped with a 4-position height
adjustment system to tailor grass cutting heights from 1.2 in. to
2.4 in. (30 mm to 60 mm). To change the cutting height of the
grass, follow the instructions below.
m
WARNING!
Before making these adjustments,
disconnect the power supply to the lawn mower and wait until
the rotating blade has come to a complete standstill. Wearing
gloves is recommended due to the close proximity of the
cutting blade.
ALWAYS FOLLOW ALL SAFETY PRECAUTIONS AND
RECOMMENDATIONS LISTED PREVIOUSLY IN THIS
MANUAL.
Grass
collection bag
handle
Grass collection bag
8
1. Power off and unplug the lawn mower.
2. To adjust the cutting height in front, place the lawn mower
on its side. Pull the mower height adjustment shaft to the
outside of the original slot (Fig. 5).
Fig. 5
Mower height
adjustment shaft
1.2.3.4.
3. Insert the shaft into the desired slot. Place the lawn mower
back on to its wheels.
4-Position Height Adjustment:
(1) 1.2 in. (30 mm)
(2) 1.6 in. (41 mm)
(3) 2.0 in. (52 mm)
(4) 2.4 in. (63 mm)
4. To adjust the cutting height in back, Pull the mower height
adjustment lever to the outside of the original slot (Fig. 6).
Fig. 6
Mower height
adjustment lever
5. Insert the lever into the slot that matches the front height
slot that the mower adjustment shaft is in.
6. Reconnect the power supply to the lawn mower and
resume normal use.
m
WARNING!
Make sure that the mower is set in the same
height on the front wheel and the rear wheel to avoid uneven
cut.