New/Former Type Discrimination; Diagrams; Note For Printed Wiring Boards And Schematic Diagrams - Sony SCD-XA777ES Service Manual

SCD-XA777ES

1. NEW/FORMER TYPE DISCRIMINATION

– MOTHER BOARD (Component Side) –
– D.OUT BOARD (Component Side) –
Former Type : 1-682-049-11
New Type : 1-682-049-12
– D-POWER BOARD (Component Side) –
Former Type : 1-682-047-11
New Type : 1-682-047-12
Former Type : 1-682-045-11
New Type : 1-682-045-12
– A-POWER BOARD (Component Side) –
Former Type : 1-682-046-11
New Type : 1-682-046-12
– AC BOARD (Component Side) –
Former Type : 1-682-048-11
New Type : 1-682-048-12

2. DIAGRAMS

2-1.

NOTE FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS

Note on Printed Wiring Board:
• X : parts extracted from the component side.
• Y : parts extracted from the conductor side.
• : Pattern from the side which enables seeing.
(The other layers' patterns are not indicated.)
Caution:
Pattern face side: Parts on the pattern face side seen from
(Conductor Side) the pattern face are indicated.
Parts face side: Parts on the parts face side seen from
(Component Side) the parts face are indicated.
• Indication of transistor
C
Q These are omitted.
B E
2 2
Note on Schematic Diagram:
• All capacitors are in µF unless otherwise noted. pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in Ω and
1 / W or less unless otherwise
4
specified.
• 5 : fusible resistor.
• C : panel designation.
Note: Note:
The components identi- Les composants identifiés par
une marque 0 sont critiques
fied by mark 0 or dotted
line with mark 0 are criti- pour la sécurité.
cal for safety. Ne les remplacer que par une
Replace only with part pièce por tant le numéro
number specified. spécifié.
• A : B+ Line.
• B : B– Line.
• Voltages and waveforms are dc with respect to ground
under no-signal conditions.
no mark : CD PLAY (ANALOG OUT)
〈〈 〉〉 : CD PLAY (DIGITAL OUT)
• Voltages are taken with a VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal produc-
tion tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
• Circled numbers refer to waveforms.
• Signal path.
J : SACD PLAY
c : CD PLAY (ANALOG OUT)
I : CD PLAY (DIGITAL OUT)