Connect The Top Duct - GE AZ91H09 Owner's Manual

Installation Instructions

Connect the Top Duct

Side View
Inside
wall
Rigid
ductwork
rigid ductwork
Air
discharge
outlet
2. Use a field supplied clamp to secure the top duct
to the air discharge outlet.
All SPVU units are factory configured to be controlled
by using a single stage heat/cool remote wall mounting
changeover as long as the control configuration
matches that of the SPVU unit.
Clamp
IMPORTANT:
AC only.
NOTICE:
electronics can result from improper connections.
black wires. No line voltage connections should
wires in building from line voltage.
Remote Thermostat
WARNING
Electric Shock Hazard
disconnect on front of the chassis.
Failure to do so can result in personal injury and/or
death.
NOTE: See the Remote Thermostat and Low
Voltage Control Connections sections
of this manual and the manual with the
separate thermostat for proper connections
and settings.
Maximum Wiring
Length for Thermostat
Connection to the Unit
66 ft. for AWG 18
60 ft. for AWG 20
40 ft. for AWG 24
AWG – American Wire Gauge
Unit Connections
49-7769