Cal Spas F-1222 Owner's Manual page 11

4 . Turn on power to the spa .
5 . Prime the pump .
After two minutes, the pump should prime. If it does not, follow the priming instructions on the next page. If it
does, continue with the next step.
6 . Install the filter into the filter canister.
7 . Adjust water chemistry .
Test and adjust the water chemistry. See the section on page 37 for instructions on water clarity.
8 . Let the spa heat up .
When the spa has finished priming, the heater will activate. Put the cover on and let the spa heat to the
set temperature.
2017 Fitness Spa
LTR20171005, Rev. D
When the spa is filled to the correct level, turn on the
power at the GFCI breaker. (Ensure that the 120V spas are
connected to the proper electrical outlet.)
Your spa will perform a self-diagnostic check and go into
Priming Mode. The control panel will display either RUN
PUMPS PURG AIR --- or Priming Mode, depending on
which control panel you have.
Do the following:
1. Press the JETS or JETS 1 button once to start the pump
in low speed.
2. Press it again to switch the pump to high speed.
3. If you have other pumps, press JETS 2 or JETS 3 to
turn them on also.
Running the pumps helps the pumps prime.
Make sure the filter has soaked at least 30 minutes
before you install it.
9
www.calspas.com