Operation Manual - Sharp XL-1000H Service Manual

XL-1000H/1100H
Setting the Clock
This may be operated only with the remote control.
In this example, the clock is set for the 24-hour (0:00) display.
1
Press the CLOCK button and within 3 seconds, press the MEMORY
button.
2
Within 1 minute, press the PRESET (
hour or 12-hour display and then press the MEMORY button.
"0:00" The 24-hour display will appear.
(0:00 - 23:59)
"AM 12:00" The 12-hour display will appear.
(AM 12:00 - PM 11:59)
Note that this can only be set when the unit is first installed or it has been reset.
Remote Control
Test of the remote control
Face the remote control directly to the remote sensor on the unit.
The remote control can be used within the range shown below:
Press the ON/STAND-BY button. Does the power turn on? Now, you can enjoy the
music.
Remote sensor
0.2 m - 6 m
(8" - 20')

OPERATION MANUAL

3
Within 1 minute, press the PRESET (
hour and then press the MEMORY button.
4
Within 1 minute, press the PRESET (
minutes and then press the MEMORY button.
To confirm the time display when the power is on:
Press the CLOCK button.
The time display will appear for about 5 seconds.
Note:
The "0:00" or time will flash at the push of the CLOCK button when the AC power
supply is restored after a power failure or unplugging the unit.
Readjust the clock as follows.
To readjust the clock:
Perform "Setting the Clock" from the beginning. If the time display is flashing, step 2
or ) button to select 24-
(for selecting the 24-hour or 12-hour display) will be skipped.
To change the 24-hour or 12-hour display:
1 Clear all the programmed contents.
2 Perform "Setting the Clock" from the beginning.
– 6 –
When the 12-hour display is selected, "AM" will change automatically to "PM".
The hour will not advance even if minutes advance from "59" to "00".
The clock starts from "0" second. (Seconds are not displayed.)
Troubleshooting Chart
If trouble occurs
When this product is subjected to strong external interference (mechanical shock,
excessive static electricity, abnormal supply voltage due to lightning, etc.) or if it is
operated incorrectly, it may malfunction.
If such a problem occurs, do the following:
1 Set the unit to the stand-by mode and turn the power on again.
2 If the unit is not restored in step 1, unplug and plug in the unit, and then turn
the power on.
3 If neither step 1 nor 2 restores the unit, do the following:
Press the ON/STAND-BY button to enter the power stand-by mode.
Unplug the AC power lead from the AC INPUT socket on the unit.
Whilst pressing down the MEMORY/SET button and the
AC power lead into the AC INPUT socket on the unit.
Caution:
This operation will erase all data stored in memory including clock, timer settings,
tuner preset, and CD programme.
or ) button to adjust the
or ) button to adjust the
button, plug the
AC INPUT