Introduction; Installing The Out-Front Mount; Installing The Helmet Mount - Garmin VARIA UT800 Owner's Manual

Introduction

See the Important Safety and Product Information guide in the
product box for product warnings and other important
information.
The device is intended for outdoor use. Without proper airflow
during use, the device may become hot. Handle with care.

Installing the Out-Front Mount

You can use the out-front mount to install the headlight and your
Edge device. Garmin recommends that you adjust the mount
®
for the Edge viewing angle before you install and adjust the
headlight angle.
1
Select a secure location to mount the Edge device and
headlight where they do not interfere with the safe operation
of your bike.
2
Use the 2.5 mm hex key to remove the screw
handlebar connector
3
If necessary, remove the two screws on the top of the mount
, rotate the connector, and replace the screws to change
the orientation of the mount for an Edge device.
4
Place a rubber pad around the handlebar:
• If the handlebar diameter is 25.4 mm, use the thicker pad.
• If the handlebar diameter is 31.8 mm, use the thinner pad.
5
Place the handlebar connector around the rubber pad.
NOTE: You should align the contours on the rubber pad with
the grooves on the inside of the handlebar connector.
6
Replace the screw, and use the 2.5 mm hex key to tighten
the screw.
NOTE: You should check the tightness of the screw
periodically.
7
Install the Edge device, and adjust the mount (optional).
8
Connect the quarter-turn adapter
Introduction
WARNING
from the
.
to the headlight.
9 Insert the screw , and hand tighten.
10
Align the notches of the quarter-turn adapter with the tabs on
the bottom of the mount.
11
Press up slightly, and turn the adapter counterclockwise until
it locks into place.
12 Adjust the headlight angle so it is parallel to the road, and
use the 4 mm hex key to tighten the screw.
NOTE: You should check the tightness of the screw
periodically.

Installing the Helmet Mount

1
Select a secure location to mount the headlight where it does
not interfere with the safety and comfort of your helmet.
2
Attach the mount using both straps.
3
Lock the straps by pressing down the clasp.
1