System Board Jumper Settings - Viglen VIG590M Manual

System Board Jumper Settings

able 4: Clear CMOS Jumper Settings
T
Functi Jumper
on (JP1)
Save 1-2
CMOS
(Default
)
Clear 2-3
NOTE: Except when clearing the rtc ram, never remove the jumper on JP1 default
position. Removing the jumper will cause system boot failures.
Table 5: Front Panel Audio Jumper Settings
Function
Normal
V1.0
Figure 3: System Board Jumper Settings
Configuration
The BIOS uses current configuration information and
passwords for booting.
Turn off the system and unplug the power cord. Move the
jumper from pins 1-2 (default) to pins 2-3 for about 5~10
seconds. Then move the jumper back to pins 1-2.
Jumper Configuration
5 – 6 The audio line signals are routed back to
the line connector.
and
9- 10
VIG590M Motherboard Manual
23