Samsung Bixolon SRP-500 Command Manual page 22

● n specifies the paper to be tested
n
0, 48 Basic sheet (paper roll)
1, 49
Paper roll
2, 50
[Notes]
When the hexadecimal dump is printed by this command, the data which is transmitted
after the command may not be printed because the printer clears the receive buffer. To
avoid this, transmit data from the host after the printer prints the starting message of
the hexadecimal dump.
This command is enabled only when processed at the beginning of a line in standard
mode.
GS I n
[Name]
[Format]
[Range]
[Function]
Bit Printer ID
1,49 Printer model ID
2,50 Type ID
3,51 ROM version ID
n = 2, Type ID
Bit Off/On
0 Off
On
1 Off
On
2 -
3 -
4 Off
5 -
6 -
7 Off
[Notes]
The printer ID is transmitted when the data in the receive buffer is developed.
Therefore, there may be a time lag between receiving this command and transmitting
the status, depending on the receive buffer status.
Rev. 1.00
Paper
Transmit printer ID
ASCII GS
Hex 1D
Decimal 29
1 ≤ n ≤ 3
Transmits the printer ID specified by n as follows:
SRP-500 series See table
below
ROM version
Hex Decimal
00 0
01 1
00 0
02 2
- -
- -
00 0
- -
- -
00 0
● m specifies a test pattern
n
1, 49
2, 50
I n
49 n
73 n
Specification
Two-byte character code not supported.
Two-byte character code supported.
Auto cutter not equipped.
Auto cutter equipped.
Undefined.
Undefined.
Not used. Fixed to Off.
Undefined.
Undefined.
Not used. Fixed to Off.
- 22 -
SRP-500
Test pattern
Hexadecimal dump
Printer status print
ID (hexadecimal)
0D
Function