Samsung Bixolon SRP-500 Command Manual page 16

[Notes]
The command is enabled only when input at the beginning of the line.
A portion of data skipped by means of HT is also target data for the justification
function.
[Default]
[Example]
Left justification
ABC
ABCD
ABCDE
ESC c 3 n
[Name]
[Format]
[Range]
[Description]
Bit Off/On
0 Off
On
1 Off
On
2 Off
On
3 Off
On
4 -
5 -
6 -
7 -
[Notes]
It is possible to select multiple detectors to output signals.
Then, if any of the detectors detects a paper end, the paper end signal is output.
Detectors are switched when executing this command.
Because of this, the paper-out signal switching may delay depending on the receive
buffer state.
[Default]
Rev. 1.00
n = 0
Select paper detector(s)to output paper end signals
ASCII ESC
Hex 1B
Decimal 27
0 ≤ n ≤ 255
Selects paper detector(s) to output paper end signals, using n as
follows:
Hex Decimal
00 0
01 1
00 0
02 2
00 0
04 4
00 0
08 8
- -
- -
- -
- -
n = 15
Centering
ABC
ABCD
ABCDE
c 3 n
63 33 n
99 51 n
Paper roll near end sensor disabled.
Paper roll near end sensor enabled.
Paper roll near end sensor disabled.
Paper roll near end sensor enabled.
Paper roll end detector disabled.
Paper roll end detector enabled.
Paper roll end detector disabled.
Paper roll end detector enable.
Undefined
Undefined
Undefined
Undefined
- 16 -
SRP-500
Right justification
Function
ABCC
ABCDC
ABCDEC