MSI X370 XPOWER GAMING TITANIUM User Manual page 66

Advanced DRAM Configuration
f
Press Enter to enter the sub-menu. User can set the memory timing for each/ all
memory channel. The system may become unstable or unbootable after changing
memory timing. If it occurs, please clear the CMOS data and restore the default
settings. (Refer to the Clear CMOS jumper/ button (optional) section to clear the CMOS
data, and enter the BIOS to load the default settings.)
DigitALL Power
f
Press Enter to enter the sub-menu. Controls the digital powers related to CPU PWM.
fCPU Loadline Calibration Control [Auto]
Sets a specific CPU loadline calibration mode for full-loading system to get good
overclocking performance and stability. If set to Auto, BIOS will configure this
setting automatically.
fCPU Over Voltage Protection [Auto]
Sets the voltage limit for CPU over-voltage protection. If set to Auto, BIOS will
configure this setting automatically. Higher voltage provides less protection and
may damage the system.
fCPU Under Voltage Protection [Auto]
Sets the voltage limit for CPU under-voltage protection. If set to Auto, BIOS will
configure this setting automatically. Higher voltage provides less protection and
may damage the system.
fCPU Over Current Protection [Auto]
Sets the current limit for CPU over-current protection. If set to Auto, BIOS will
configure this setting 0utomatically.
[Auto]
[Enhanced]
fCPU Switching Frequency [Auto]
Sets the PWM working speed to stabilize CPU Core voltage and minimize ripple
range. Increasing the PWM working speed will cause higher temperature of
MOSFET. So please make sure a cooling solution is well-prepared for MOSFET
before you increase the value. If set to Auto, BIOS will configure this setting
automatically.
fCPU VRM Over Temperature Protection [Auto]
Sets the temperature limit on CPU VRM for over-temperature protection. The CPU
frequency may be throttled when CPU temperature over the specified temperature.
If set to Auto, BIOS will configure this settings.
fCPU Power Duty Control [Thermal Balance]
Selects the method of CPU VRM phase control.
[Thermal Balance] Controls the VRM with thermal balance mode.
[Current Balance] Control the VRM with current balance mode.
fCPU NB Loadline Calibration Control [Auto]
Sets a specific CPU-NB loadline calibration mode for full-loading system to get
good overclocking performance and stability. If set to Auto, BIOS will configure this
setting automatically.
66
BIOS Setup
This setting will be configured automatically by BIOS.
Extends the current range for over-current protection.