Removing Or Replacing The Hdd Cage - NEC 120Ef User Manual

Removing or replacing the HDD Cage

Unplug the power cord from the wall outlet before installation. If you
touch parts inside the controller with the power cord plugged, there is a
risk of an electric shock.
Pull out the power cord by holding onto the plug. Pulling the cord may
damage the cord coating resulting in power leakage or electric shock.
When installing or removing this controller, do not insert or remove the
plug for the system with wet hands. Otherwise there is a risk of an
electric shock.
The internal parts of the system are very hot immediately after the
power is turned off. Make sure that the temperature is low enough
before installing the HDD Cage.
1. Terminate all the applications running and shut down the system.
2. Turn off the power of the system and then remove all the power cords of the power unit
from the wall outlet.
3. Remove the side cover and components refering to the system user's guide.
4. Open the front door of the system and remove the installed hard disk drives.
them.
5. Remove all cables from the HDD Cage.
6. Remove the six screws securing the HDD Cage and carefully pull the HDD cage out of
the system.
Handling the HDD Cage 2-2
Note:
Note the installation of hard disk drives before removing
WARNING
CAUTION